Deck Wall Hanger Assembly Instructions

Every Venom Skateboards Deck Wall Hanger started life as a regular skateboard deck. We take tired, thrashed, snapped skateboards and give them new life by recycling them to make these fantastic mounts to display your favourite decks. This means each wall mount will be unique, carrying the history and battle scars from its former life!

Watch our instructional video here:

The Pack Includes:

1 x HANGER BASE

1 x WALL PLUG & SCREW

2 x MOUNTING BOLTS

6 x MOUNTING NUTS

You will also need:

• 7mm Spanner to tighten the hanger nuts.

• Drill and 6mm masonry drill bit for the wall plug.

• Phillips screwdriver to tighten the screw to the wall and the mounting bolts.

• A pencil for marking the wall.

Assembly

1. Assemble Wall Hanger Mounting Bolts

Insert mounting bolts through the rear and tighten a nut with a Philips screwdriver and spanner to secure. (fig.1)

Fig 1

Position another nut on each bolt proximately 20mm from the tip as a back stop for the deck. Be sure all nuts are the correct way round. (fig.2)

2. Attach Hanger To The Wall

IMPORTANT!

Please take extra care when drilling, make sure there are no pipes or electric wires in the wall where you will make the hole. We accept no responsibility for damage to walls or property, use at your own risk. DIY can be dangerous please ask a responsible and competent adult to help.

Hold the hanger in the desired position on your wall. Mark the wall through the middle hole. Drill a hole for the wall plug. Insert wall plug then screw through the hanger base into the wall plug.

Fig 3

3. Mount Your Deck

Hold your deck up to the hanger bolts and insert them through the upper most deck holes. Screw on the outer nuts to secure your deck in place. Fine tune the position of the nuts on the hanger bolts to best suit your deck.

Now stand back and admire your wall mounted deck display!